This question is at best about how R is configured on your computer, but far
more likely the problem lies in your operating system, which you have not
identified and details of which are off-topic here anyway.
If you use getwd() to identify which directory you are in, or pay attention to
which directories you are specifying, then you have to examine the permissions
on each such directory using whatever tools your operating system gives you to
learn about those directories. Regardless, fixing permissions problems is
off-topic here.
---------------------------------------------------------------------------
Jeff Newmiller The ..... ..... Go Live...
DCN:<jdnew...@dcn.davis.ca.us> Basics: ##.#. ##.#. Live Go...
Live: OO#.. Dead: OO#.. Playing
Research Engineer (Solar/Batteries O.O#. #.O#. with
/Software/Embedded Controllers) .OO#. .OO#. rocks...1k
---------------------------------------------------------------------------
Sent from my phone. Please excuse my brevity.
Nick Duncan <nickd...@gmail.com> wrote:
>Dear All,
>
>I was just installing 'linkcomm' and had the following message which I
>have not seen before and don't really understand:
>
>NOTE: To use linkcomm, you require read and write permissions in the
>current directory (see: help("getwd"), help("setwd"))
>
>Having looked at these help pages I'm none the wiser.
>
>Any advice much appreciated?
>
>Best,
>Nick Duncan
>
>______________________________________________
>R-help@r-project.org mailing list
>https://stat.ethz.ch/mailman/listinfo/r-help
>PLEASE do read the posting guide
>http://www.R-project.org/posting-guide.html
>and provide commented, minimal, self-contained, reproducible code.
______________________________________________
R-help@r-project.org mailing list
https://stat.ethz.ch/mailman/listinfo/r-help
PLEASE do read the posting guide http://www.R-project.org/posting-guide.html
and provide commented, minimal, self-contained, reproducible code.
