On Monday 15 November 2010 19:21:58 ext Haipeng Jin wrote:
> Hi,
>
> I am learning to use qtcreator and encountered the following problem: when I
> launch debugger in qtcreator, the disassembly windows always pops out. As a
> result, I can only step through the disassembly code instead of the c source
> code. Trying to close the disassembly window and switching to c source code
> window does not help, as soon as I press F10 again, the disassembly window
> shows up again. I tried to toggle the “Operate by instruction” setting, it
> does not help either.
>
> I am running qtcreator 2.0.1 under Linux with Qt-4.7.0. The debugger is
> default gdb.
>
> Any idea on what is happening?
This might be a build without debug information. Check whether there's a "-g"
present on the compiler command lines in the "Compile Output" pane. If it is,
send the debugger log ({Windows,Debug}->Views->Debugger, right pane).
Andre'
_______________________________________________
Qt-creator mailing list
[email protected]
http://lists.trolltech.com/mailman/listinfo/qt-creator
