On Sun, Jul 09, 2017 at 11:02:19PM +0200, Eric Auger wrote: > From: Pranavkumar Sawargaonkar <[email protected]> > > Now we are able to retrieve the gsi from the INTx pin, let's > enable intx_to_irq routing. From that point on, irqfd becomes > usable along with INTx when assigning a PCIe device. > > Signed-off-by: Pranavkumar Sawargaonkar <[email protected]> > Signed-off-by: Tushar Jagad <[email protected]> > Signed-off-by: Eric Auger <[email protected]> > --- > hw/pci-host/gpex.c | 12 ++++++++++++ > 1 file changed, 12 insertions(+) > > diff --git a/hw/pci-host/gpex.c b/hw/pci-host/gpex.c > index 0d42ac2..94cc3c1 100644 > --- a/hw/pci-host/gpex.c > +++ b/hw/pci-host/gpex.c > @@ -53,6 +53,17 @@ int gpex_set_irq_num(GPEXHost *s, int index, uint32_t gsi) > return 0; > } > > +static PCIINTxRoute gpex_route_intx_pin_to_irq(void *opaque, int pin) > +{ > + PCIINTxRoute route; > + GPEXHost *s = opaque; > + > + route.mode = PCI_INTX_ENABLED; > + route.irq = (int)s->irq_num[pin]; > + > + return route; > +} > + > static void gpex_host_realize(DeviceState *dev, Error **errp) > { > PCIHostState *pci = PCI_HOST_BRIDGE(dev); > @@ -77,6 +88,7 @@ static void gpex_host_realize(DeviceState *dev, Error > **errp) > &s->io_ioport, 0, 4, TYPE_PCIE_BUS); > > qdev_set_parent_bus(DEVICE(&s->gpex_root), BUS(pci->bus)); > + pci_bus_set_route_irq_fn(pci->bus, gpex_route_intx_pin_to_irq); > qdev_init_nofail(DEVICE(&s->gpex_root)); > } > > -- > 2.5.5 > >
Wouldn't need the cast if irq_num was an array of ints, but otherwise Reviewed-by: Andrew Jones <[email protected]>
