The BIT6 of Status Register(SR):
SR[6] behaves the same as R/B# pin
SR[6] = 0 indicates the device is busy;
SR[6] = 1 means the device is ready
Some NAND flash controller (i.e. ftnandc021) relies on the SR[6]
to determine if the NAND flash erase/program is success or error timeout.
P.S:
The exmaple NAND flash datasheet could be found at following link:
http://www.mxic.com.tw/QuickPlace/hq/PageLibrary4825740B00298A3B.nsf/h_Index/8FEA549237D2F7674825795800104C26/$File/MX30LF1G08AA,%203V,%201Gb,%20v1.1.pdf
Signed-off-by: Kuo-Jung Su <[email protected]>
---
hw/nand.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/hw/nand.c b/hw/nand.c
index 4a71265..61e918f 100644
--- a/hw/nand.c
+++ b/hw/nand.c
@@ -46,7 +46,7 @@
# define NAND_IOSTATUS_PLANE1 (1 << 2)
# define NAND_IOSTATUS_PLANE2 (1 << 3)
# define NAND_IOSTATUS_PLANE3 (1 << 4)
-# define NAND_IOSTATUS_BUSY (1 << 6)
+# define NAND_IOSTATUS_READY (1 << 6)
# define NAND_IOSTATUS_UNPROTCT (1 << 7)
# define MAX_PAGE 0x800
@@ -231,6 +231,7 @@ static void nand_reset(DeviceState *dev)
s->iolen = 0;
s->offset = 0;
s->status &= NAND_IOSTATUS_UNPROTCT;
+ s->status |= NAND_IOSTATUS_READY;
}
static inline void nand_pushio_byte(NANDFlashState *s, uint8_t value)
--
1.7.9.5
