Faiq Ali Sayed <faiqueali....@gmail.com> writes: > Hi everyone, > I am facing an issue during booting QNX VM using Qemu, > I have an image to Boot the VM. and when I trigger a Qemu command to create a > VM it is stuck. > I also used a debugger to investigate but I can not see any result by GDB. > > Here is the output of first windows > > qemu-system-aarch64 -M xlnx-zcu102 -m 16G -serial mon:stdio -display none > -device > loader,file=QNX-IFS,addr=0x00100000,cpu-num=0 -drive > file=/home/faiq/Downloads/install/BootSD/qemu-boot_sd.img,if=sd,format=raw,index=1 > -boot mode=5 -net > nic,model=cadence_gem -net nic,model=cadence_gem -net nic,model=cadence_gem > -net > nic,model=cadence_gem,netdev=xzynq0 -netdev user,id=xzynq0,tftp=/tftpboot > -nographic -global > xlnx,zynqmp-boot.cpu-num=0 -global 'xlnx,zynqmp-boot.use-pmufw=true' -s -S > > qemu-system-aarch64: warning: hub 0 is not connected to host network
Is this QNX VM image built for the xlnx-zcu102 board? > on the other hand, here is the output of GDB: > > (gdb) target remote :1234 > Remote debugging using :1234 > warning: No executable has been specified and target does not support > determining executable automatically. Try using the "file" command. > 0x0000000000100000 in ?? () > (gdb) c > Continuing. You'll either want the debug symbols for your image or tell GDB what the target arch is. Check you are somewhere sane by doing: x/10i $pc and step through the instructions and see where it goes. If you hit Ctrl-C are you executing nonsense instructions or in a tight loop hanging? -- Alex Bennée Virtualisation Tech Lead @ Linaro
