On Wed, 10 Jan 2024 at 23:42, Nabih Estefan <[email protected]> wrote:
>
> From: Hao Wu <[email protected]>
>
> This patch implements the basic registers of GMAC device and sets
> registers for networking functionalities.
>
> Tested:
> The following message shows up with the change:
> Broadcom BCM54612E stmmac-0:00: attached PHY driver [Broadcom BCM54612E]
> (mii_bus:phy_addr=stmmac-0:00, irq=POLL)
> stmmaceth f0802000.eth eth0: Link is Up - 1Gbps/Full - flow control rx/tx
>
> Change-Id: If71c6d486b95edcccba109ba454870714d7e0940
> Signed-off-by: Hao Wu <[email protected]>
> Signed-off-by: Nabih Estefan Diaz <[email protected]>
> Reviewed-by: Tyrone Ting <[email protected]>
> ---
This patch doesn't compile at this point in the series, because:
> +static void npcm_gmac_write(void *opaque, hwaddr offset,
> + uint64_t v, unsigned size)
> +{
> + NPCMGMACState *gmac = opaque;
...
> +
> + gmac_update_irq(gmac);
the function gmac_update_irq() isn't defined until
later in the series.
The easy fix is to squash "include/hw/net: General GMAC Implementation"
(which incidentally still has a commit message subject that
doesn't match its contents) into this one, since it's
not very large.
-- PMM
