Hello Stu!
Thank you so so much for your feedback! I will update my
ports later.
Thomas
On 6/9/26 01:14, Stuart Henderson wrote:
On 2026/06/09 00:54, Thomas Dettbarn wrote:
+
+*** WARNING *** You might need to recompile the kernel.
+Some devices have problems when they are accessed through uftdi(4). One
+of the ways to disable them for this module is by commenting out their
+USB IDs in /usr/src/sys/dev/usb/uftdi.c. Like so:
+
configuring the kernel via the bsd.re-config(5) mechanism would
usually be the most convenient way to do this and I think I would
avoid suggesting other methods. basically you would want to add
the disable line to /etc/bsd.re-config, run /usr/libexec/reorder_kernel,
and reboot.
Nice!
I did not know about this method. I will try it, if it works, then I
will update the README.
UNFORTUNATELY, with my setup, I encountered a problem where
I need this module, albeit not for loading the FPGA board itself: A
second USB device I had (Which I used for UART communication
with my design) did not work with ugen(4).
So removing uftdi(4) completely was too much, I needed to be
more precise. Hence my suggestion with the kernel patch.
