------------------------------ Original Message ------------------------------ Subject: Re: [qBittorrent] I2P features seems to not work From: beecdadd...@danwin1210.de Date: Sat, January 27, 2024 7:24 pm To: "Klemens Nanni" <k...@openbsd.org> ------------------------------------------------------------------------------
i2pd is easy, you edit /etc/i2pd/i2pd.conf to your ability. default speed is 32 KB/sec, maybe is too low, maybe you crash your system or router I2Pd is similar to Tor, but is it's own network and unless you specify an 'outproxy' in i2pd.conf, you cannot visit clerrnet sites, only eepsites ending in .i2pd like http://openbsd.i2p (remember I2P software has to run for a few minutes up to hours to integrate well into network) so maybe try that. I2Pd is not VPN, I replied to i2pd post recently. qBittorrent no special options or configuration other than what I said already. I did not find any I2P guides on qBittorrent, not any recent or official. There is under Connection I2P (experimental), I turned it on and that should be it? I don't know help me please On Wed, January 24, 2024 11:01 pm, Klemens Nanni wrote: > Please provide exact instructions on how to set up i2pd and qbittorrent. > > > I installed i2pd, followed its README, read the config and --help > output, looked through https://i2pd.website, but couldn't make a simple 'curl > --socks5 127.0.0.1:4447 openbsd.org' work (4447/tcp being i2pd's > default SOCKS5 port) -- the proxy connection works, but i2pd fails after that > and it constantly spews warning that don't help. > > On Wed, Jan 24, 2024 at 12:52:15PM -0000, beecdadd...@danwin1210.de wrote: > >> (After 1 week I figured out how to subscribe to a list by reading the >> entire OpenBSD's page until the end) >> >> Hello >> This is my 1st post to ports list, tell me if I'm missing anything. >> >> >> I am running -current both OpenBSD and ports(pkg_add). >> >> >> So the problem is that in qbittorrent the I2P experimental feature does >> not work like AT ALL.. I added 4 torrents over the biggest I2P tracker >> postman and I seem to only get 'Stalled' it says 0 peers I am running i2pd >> port on same machine Is this problem with qBittorrent libtorrent i2pd or >> some settings I didn't see anywhere that had to be enabled or disabled? I >> enabled the I2P experimental option, the port specified default port points >> to the SAM protocol Here is the full Execution log: >> >> >> >> UPnP/NAT-PMP port mapping failed. Message: "could not map port using >> UPnP[192.168.1.170]: no router found" >> UPnP/NAT-PMP port mapping failed. Message: "could not map port using >> UPnP[192.168.1.170]: no router found" >> Detected external IP. IP: "[REDACTED]" >> IP geolocation database loaded. Type: DBIP-Country-Lite. Build time: >> [REDACTED] >> Restored torrent. Torrent: "[TUTORIAL] How to[REDACTED]" >> Restored torrent. Torrent: "Full[REDACTED]" >> Restored torrent. Torrent: "i2p[REDACTED]" >> Restored torrent. Torrent: "The[REDACTED]" >> Successfully listening on IP. IP: "fe80::1%lo0". Port: "UTP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "fe80::1%lo0". Port: "TCP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "::1". Port: "UTP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "::1". Port: "TCP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "192.168.1.170". Port: "UTP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "192.168.1.170". Port: >> "TCP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "127.0.0.1". Port: "UTP/[RANDOM-PORT]" >> Successfully listening on IP. IP: "127.0.0.1". Port: "TCP/[RANDOM-PORT]" >> UPnP/NAT-PMP support: ON >> Encryption support: ON >> Anonymous mode: ON >> Peer Exchange (PeX) support: ON >> Local Peer Discovery support: ON >> Distributed Hash Table (DHT) support: ON >> HTTP User-Agent: "qBittorrent/4.6.3" >> Peer ID: "[REDACTED]" >> Trying to listen on the following list of IP addresses: >> "0.0.0.0:[RANDOM-PORT],[::]:[RANDOM-PORT]" >> Using config directory: /home/[USER]/.config/qBittorrent >> qBittorrent v4.6.3 started >> >> >> Thanks for maintenance. >> >> >> >
