On 12/11/20 11:30 AM, Ken Stephens wrote:
Galen,
Yes I did before I soldered it to the board. Even checked the voltage:
3.22 V.
I suggest disconnecting the ft232 module from the prop board, and then
trying to connect the ft232 to a known good USB port with a known good
cable. This should tell you whether the ft232 is functional.
Regarding drivers, I would expect any contemporary Linux kernel to
already have the appropriate driver for an FTDI USB-serial device.
galen
--
Galen Seitz
[email protected]
_______________________________________________
PLUG: https://pdxlinux.org
PLUG mailing list
[email protected]
http://lists.pdxlinux.org/mailman/listinfo/plug
