> On May 10, 2020, at 10:56 AM, Mark C <[email protected]> wrote:
>
> I had the same experience with a Metz 58 AF-2 - a firmware update was needed
> to work with the K1.
Now that you mention it, so did I.
>
> Mark
>
> On 5/8/2020 1:16 PM, Henk Terhell wrote:
>> Not driver, new firmware I mean.
>>
>> Op 2020-05-08 om 19:15 schreef Henk Terhell:
>>> I had a problem with P-TTL of my Metz 48 AF-1 until I installed a new
>>> driver.
>>> Perhaps this works for yours too?
>>>
>>> Henk
>>>
>>> Op 2020-05-08 om 18:37 schreef Igor PDML-StR:
>>>>
>>>> Hi All!
>>>>
>>>> I am still figuring out my ways with the K-1 I finally got recently.
>>>>
>>>> I've discovered a strange behavior with my Metz 58-AF-1 flash:
>>>> K-1 refuses to fire it when it is set in P-TTL mode.
>>>> It works in "A", and, - it works in P-TTL-HS (high-speed).
>>>>
>>>> Does anybody know why that is so?
>>>> I thought the high-speed mode was an "extra" - that some cameras could
>>>> utilize *in addition* to P-TTL, - for faster shutter speeds, but that all
>>>> P-TTL capable cameras should be able to work with P-TTL setting.
>>>> (Both K-7 and K-5IIs were working just fine with P-TTL.)
>>>>
>>>> Any ideas?
>>>>
>>>> Igor
>>>>
>>>>
>>>
>>
>>
>
>
> --
> PDML Pentax-Discuss Mail List
> [email protected]
> http://pdml.net/mailman/listinfo/pdml_pdml.net
> to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
> the directions.
>
--
Larry Colen
[email protected]
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
