P.J. Alling wrote:
Geez Larry where did you find that three to one fitting?
OSH (Orchard Supply Hardware), it's a 3 to 1 manifold for air tools. I
have one on my compressor.
Here's one online:
https://www.zoro.com/speedaire-air-gun-manifold-38-fnpt-in-14-out-22yk88/i/G9050151/?gclid=CjwKEAjwltC9BRDRvMfD2N66nlISJACq8591RS__bySrynHcQlhs89cr47iWvHmRKkyw0HAOoEWdWhoCNxbw_wcB&gclsrc=aw.ds
It cost me $20 in the store and was the most expensive part of the big
dumb tripod.
On 8/17/2016 4:31 PM, Larry Colen wrote:
A few years back I decided that I needed an ultra sturdy tripod, and
decided that I could make one for far less than the cost of buying one.
Mind you, this barely qualifies as "luggable", and what little
adjustability it has is from swapping out the "legs". However, it cost
me under $100 (closer to $50 IIRC) and is certainly sturdy.
https://www.flickr.com/photos/ellarsee/sets/72157619815658015
--
Larry Colen [email protected] (postbox on min4est) http://red4est.com/lrc
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
