In the time taken to read this thread, I could have decided which film
to put in my 67II. Much too embarassing to tell you how many other
threads I could read in the time taken to load it!!

Peter

On 11/27/06, Adam Maas <[EMAIL PROTECTED]> wrote:
> Godfrey DiGiorgi wrote:
> > On Nov 26, 2006, at 12:43 PM, Jens Bladt wrote:
> >
> >> That's a film change, right?
> >> Two minutes?
> >> Perhaps a little less.
> >> Even memory cards must be exchanged form time to time...
> >
> > A 2G memory card on the *ist DS takes less than four seconds to
> > exchange and holds approx 197 exposures. That's 8.2 minutes of
> > shooting time with the shutter release held down in continuous mode.
> >
> > A 36 exposure roll of film in the MZ-S is completed in 15 seconds.
> > Let's be optimistic and say it takes a minute to rewind and change
> > the film. So in the same 8.2 minutes of "continuous" shooting, you
> > might make up to 40 exposures more with film ... but it would be less
> > continuous, and I honestly doubt you could do it in practice. You'll
> > fall behind after the card change, and if the *ist DS started with a
> > 4G card, you'd not even keep up with the first card.
> >
> > Of course, the point is utterly moot. I can see little to no reason
> > to do such stuff. I often do not expose 40 frames in an entire day's
> > shooting.
> >
> > Godfrey
> >
>
> A minute would be very slow for a modern film camera with a drive. I can
> rewind and load my F3/MD-4 in half that (rewind on the MD-4 is well
> under 10 seconds, 4.5 seconds with the MN-2 that I don't have. I'd
> expect the MZ-S is in the 10-15 second range given the slower drive).
> Loading is simple, drop in and pull to the mark, then close.
>
> I'd expect to shoot at least 8 rolls in 8 minutes If I'm trying. At 36
> exposures that's 288 exposures, about 50% more than the DS can do.
>
> -Adam
>
> --
> PDML Pentax-Discuss Mail List
> [email protected]
> http://pdml.net/mailman/listinfo/pdml_pdml.net
>

-- 
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net

Reply via email to