Bruce,
Thank you. This is the information I was after. Pressing and holding
the "Light" button is somehow not intuitive.
Leon
http://www.bluering.org.au
http://www.bluering.org.au/leon
Bruce Dayton wrote:
Two basic things you have to do. First, with the flash on, hold down
the 'Light' button for 2 seconds. It will change to say Slave 1
or Slave 2. You must set it to slave 2 by pressing the s (select)
button. Then press the 'Light' button to save.
Next you need to set the power switch to the middle position. The
power light will blink to show it is ready. It should then trigger
from another flash. You can set manual or Automatic mode at this
point.
