Hi kai:
Check this:
https://www.packetfence.org/doc/PacketFence_Installation_Guide.html#_adjust_switch_configuration_in_packetfence<https://www.packetfence.org/doc/PacketFence_Installation_Guide.html%23_adjust_switch_configuration_in_packetfence>
发件人: Kai Bass (Westfalia Spielgeräte GmbH) via PacketFence-users
<[email protected]>
发送时间: 2024年4月15日 21:59
收件人: [email protected]
抄送: Kai Bass (Westfalia Spielgeräte GmbH) <[email protected]>
主题: [PacketFence-users] VLANs Problem
Hello everyone,
I have successfully installed Packetfence with Active Directory authentication.
However, I am encountering some issues while trying to grant my test client
access to a specific VLAN. My Clients dont get any IP Informations.
Currently, we are only using the default VLAN (1), which is assigned to all our
IP addresses (172.25.0.0/24) and where my Access switch and Packetfence VM are
located.
Can VLANs be configured using the IP range 192.168.0.0/24 in this setup? If
yes, what are the considerations?
Is a secondary NIC required? Do i need to configure the Switchport where the
packetfence server is connected as Trunk and do i need to see my VM-MAC-Adress
with "sh lldp info remote-device"? And do i need to configure my Access Port
where my test-client is connected as Trunk with all VLANS too?
Do i need to configure something spezial in VMware Workstation Player other
than my NICs as brided? How could i trobleshoot this problem?
Thank you very much for any help!
Regards,
Kai
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users
