--On Tuesday, September 15, 2020 9:50 PM +0200 Stefan Kania
<[email protected]> wrote:
I did a lot of changes to my configuration via Ansible. Here is my
provider configuration:
dn: olcOverlay={0}syncprov,olcDatabase={1}mdb,cn=config
objectClass: olcOverlayConfig
objectClass: olcSyncProvConfig
olcOverlay: syncprov
olcSpCheckpoint: 100 10
olcSpSessionlog: 300
You have no ACCESSLOG OVERLAY here on your primary DB, which is not a valid
delta-sync configuration.
dn: olcOverlay={0}accesslog,olcDatabase={3}mdb,cn=config
objectClass: olcOverlayConfig
objectClass: olcAccessLogConfig
olcOverlay: accesslog
olcAccessLogDB: cn=accesslog
olcAccessLogOps: writes
olcAccessLogPurge: 01+00:00 00+04:00
olcAccessLogSuccess: TRUE
You have an ACCESSLOG OVERLAY here on your *accesslog* db, which is
completely invalid.
dn: olcOverlay={1}syncprov,olcDatabase={3}mdb,cn=config
objectClass: olcOverlayConfig
objectClass: olcSyncProvConfig
olcOverlay: {1}syncprov
olcSpCheckpoint: 100 10
olcSpSessionlog: 300
--------------------
You have an invalidly configured SYNCPROV OVERLAY on the accesslog DB. The
only valid config items for the syncprov overlay on the accesslog db are:
olcSpNoPresent: TRUE
olcSpReloadHint: TRUE
To summarize:
For delta-syncrepl, the PRIMARY db must have a SYNCPROV and ACCESSLOG
overlay defined. The ACCESSLOG db must have a SYNCPROV overlay defined and
it MUST set olcSpNoPresent to TRUE and olcSpReloadHint to TRUE.
Regards,
Quanah
--
Quanah Gibson-Mount
Product Architect
Symas Corporation
Packaged, certified, and supported LDAP solutions powered by OpenLDAP:
<http://www.symas.com>
