> From: Jan Owoc [mailto:[email protected]]
> Sent: Friday, August 10, 2012 11:50 PM
>
> > Where is a good place to report this bug?
>
> The issue tracker is:
> https://www.illumos.org/projects/openindiana/issues
So, this is a common problem with a lot of open source projects. In order to
report a bug, you have to reproduce it, go to the website, create an account,
with email verification, and in this case, ssh keys for some reason...
Most people wouldn't have bothered, but I actually reformatted my system in
order to reproduce the bug. I'm not going to register on the bug tracker...
But here are my notes, just in case anybody will enter it, who will bother with
the effort:
Yes, this morning, I reformatted and recreated the bug. I suspect most of the
steps below are irrelevant, but the root cause is unknown, so it is therefore
unknown if this bug will apply in any more general sense, but the following
specific steps are sufficient. (I suspect it does apply in a general sense,
because there are reports all over the internet, of people having trouble
enabling zfs auto-snapshot, er, Time Slider on openindiana. In fact, the OI
manual conspicuously doesn't say anything about enabling snapshots.)
boot from openindiana 151a5 desktop dvd
default keyboard, language
launch "Install Openindiana"
Select a disk, use whole disk.
New York. English.
Set root password, including a "," character. (Is the "," actually necessary?
Not sure.)
Create a user account with the same pass.
Unfortunately, the installer doesn't give you any option to eject CD. Just do
it when you can, or sudo eject later.
After it boots for the first time, login as jsmith (while still at physical
console).
(if needed) sudo eject
##############################
# Probably can skip everything below this, between these two markers.
##############################
Set yourself a static IP as follows:
adapted from http://wiki.openindiana.org/oi/Static+IP
ifconfig -a
(Make a note of the interface name, you're going to need it.
in this case, I have bge0)
sudo svcadm disable svc:/network/physical:nwam
sudo ipadm create-addr -T static -a 192.168.1.50/24 bge0/v4static
sudo route -p add default 192.168.1.1
sudo vi /etc/hosts /etc/resolv.conf
sudo cp /etc/nsswitch.dns /etc/nsswitch.conf
sudo svcadm enable svc:/network/physical:default
Now you should be able to ssh in.
Install your ssh keys, if you're going to.
Make it so jsmith doesn't need password for sudo (you're going to need this for
cron to set time, at least.)
sudo visudo
Go to the end, find the "jsmith" line, and change it:
(before) jsmith ALL=(ALL) ALL
(after) jsmith ALL=(ALL) NOPASSWD: ALL
Enable compression and disable ZIL
for fs in rpool/ROOT/openindiana rpool/export rpool/export/home
rpool/export/home/jsmith ; do sudo zfs set compression=on $fs ; sudo zfs set
sync=disabled $fs ; done
Apply updates
sudo pkg update
(At the time of this writing, No updates available.)
##############################
# Probably can skip everything above this, between these two markers.
##############################
Enable snapshots
In the GUI, go to System / Administration / Time Slider
Note: For some reason this wouldn't start. No matter how many times I try
to launch it, type in password, it just disappears.
It says "Starting Time Slider" in the task bar, for a few seconds, and
disappears.
Launch a Terminal. Become root. (sudo su -)
passwd jsmith (make up something temporary)
passwd root (make up something temporary)
passwd jsmith (put it back to the original value)
passwd root (put it back to the original value)
Now try launching Time Slider again. Magically it works. That is a bug,
my friends.
_______________________________________________
OpenIndiana-discuss mailing list
[email protected]
http://openindiana.org/mailman/listinfo/openindiana-discuss
