Hi!
I think you are another victim of bug #1333. See
https://www.illumos.org/issues/1333
for the details. Changing the mode of the APIC timer by adding the line
set apix:apic_timer_preferred_mode = 0x0
to /etc/system works for me - at least as a workaround until a new OI
release will be
available.
Regards,
Henner
> I recently got a new machine and installed oi_151a from scratch (core
i7-2600, intel
> motherboard DH67BL, 16GB RAM). After a few days uptime I noticed a
constant system
> load of about 10% although the desktop was idle and I had not started
anything that
> caused a permanent load. There was almost no I/O activity, just a few
reads and writes
> every few seconds. vmstat showed 0-1% user time but 10-13% system
time. prstat -v output
> was far below 1% or 0% user and system time for all processes. Over
the following days
> the load increased further. When I took 7 cpu cores off-line I got
about 80% sys load
> on the remaining core. Where does it come from?
_______________________________________________
OpenIndiana-discuss mailing list
[email protected]
http://openindiana.org/mailman/listinfo/openindiana-discuss
