On Fri, Apr 1, 2011 at 3:09 PM, Roy Sigurd Karlsbakk <[email protected]> wrote: >> I had done an OI install onto a PATA disk. After reboot, I followed a >> howto to convert the rpool into a mirror, and it seems to all work. >> However, when I run the format command, I see this: >> >> AVAILABLE DISK SELECTIONS: >> 0. c1d0 <ð¦äþäþPp¸nHãþ®ÈpÀ…äþð¦äþäþppØn0"ãþõ cyl 19454 alt 2 hd 255 >> sec 63> >> /pci@0,0/pci-ide@4/ide@0/cmdk@0,0 >> 1. c1d1 <ð¦äþäþPp¸nHãþ®ÈpÀ…äþð¦äþäþppØn0"ãþõ cyl 19454 alt 2 hd 255 >> sec 63> >> /pci@0,0/pci-ide@4/ide@0/cmdk@1,0 >> >> Does it seem like I hosed the label or something? I can boot from this >> rpool and everything *seems* to work. Not sure if I should be >> concerned >> or not? > > I've seen something similar at times, but never seen actual problems. > Doublecheck that it boots from both side of the mirror - just remove the > primary and try...
I can confirm the same thing on an AMD Athlon XP with PATA controllers. I was trying to dump some data off the second disk, and noticed the same issue. Ben _______________________________________________ OpenIndiana-discuss mailing list [email protected] http://openindiana.org/mailman/listinfo/openindiana-discuss
