Hi
I'm evaluating OpenIndiana with Crossbow and Zones. So I want to setup one
Host with five Zones. At first in my environment at home, everything
should be available in the same network 192.168.2.0. The same with an
another network in a datacenter later.
The host has got a statically configured Interface with the IP
192.168.2.201. Gateway and DNS Server are 192.168.2.1.
After dladm create-vnic -l e1000g0 vnic0 I have no working network
anymore. Only if I chose vnic0 then as the network interface I could
assign to my Network again.
darko@masterzone:~# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
vnic0: flags=1100843<UP,BROADCAST,RUNNING,MULTICAST,ROUTER,IPv4> mtu 1500
index 2
inet 192.168.2.201 netmask ffffff00 broadcast 192.168.2.255
ether 2:8:20:b5:44:d6
lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252
index 1
inet6 ::1/128
darko@masterzone:~# dladm show-link
e1000g0 phys 1500 up -- --
vnic0 vnic 1500 up -- e1000g0
vnic1 vnic 1500 up -- e1000g0
vnic2 vnic 1500 up -- e1000g0
vnic3 vnic 1500 up -- e1000g0
vnic4 vnic 1500 up -- e1000g0
vnic5 vnic 1500 up -- e1000g0
Later I have created my first Zone
zonecfg -z mailserver
create
set zonepath=/rpool/zones/mailserver
set ip-type=exclusive
add net
set physical=vnic1
end
exit
zoneadm -z mailserver install
zoneadm -z mailserver boot
After I have finished the setup of the Zone I could access via Network the
Host with 192.168.2.201. But not the rest of my network. And from the
network I could only access the Host. IPv4 forwarding is activated
(routeadm -u -e ipv4-forwarding)
So my questions are what I did wrong? Or what is going wrong? Do I need a
bridge for this setup?
kind regards,
Darko
_______________________________________________
OpenIndiana-discuss mailing list
[email protected]
http://openindiana.org/mailman/listinfo/openindiana-discuss
