Set the supported field of the phydev to indicate the speed features
of the phy. If the phy is never attached to a netdev, but used in an
adjust_link() function, the speed will be incorrectly evaluated to
10/half rather than the correct speed/duplex.
Signed-off-by: Andrew Lunn <and...@lunn.ch>
---
drivers/net/phy/fixed_phy.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/net/phy/fixed_phy.c b/drivers/net/phy/fixed_phy.c
index 1a400ef92d65..7244336dee7a 100644
--- a/drivers/net/phy/fixed_phy.c
+++ b/drivers/net/phy/fixed_phy.c
@@ -296,6 +296,18 @@ struct phy_device *fixed_phy_register(unsigned int irq,
phy->dev.of_node = np;
phy->is_pseudo_fixed_link = true;
+ switch (status->speed) {
+ case SPEED_1000:
+ phy->supported = PHY_1000BT_FEATURES;
+ break;
+ case SPEED_100:
+ phy->supported = PHY_100BT_FEATURES;
+ break;
+ case SPEED_10:
+ default:
+ phy->supported = PHY_10BT_FEATURES;
+ }
+
ret = phy_device_register(phy);
if (ret) {
phy_device_free(phy);
--
2.5.0
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
