On Thu, 17 Jan 2008 23:13:50 +0100, Mikael Pettersson wrote:
> The problematic machine has an Intel P965/ICH8R based ASUS P5B-E Plus
> mainboard with a Core2Duo 6600 processor. Kernels up to and including
> 2.6.24-rc7 work fine on it.
>
> Kernel 2.6.24-rc8 boots Ok, but if I try to do a warm reboot after
> having run 2.6.24-rc8, the BIOS hangs. The initial BIOS screen shows:
>
> <BIOS version>
> <CPU identification>
> <lists hotkeys>
> <identifies RAM>
> <initialises USB controllers>
> [here it always hangs after having run 2.6.24-rc8]
> <RAM test>
> <identifies ATA disks>
>
> Pressing reset will not fix the hang, nor will powering the machine
> down using the mainboard's power button. The only thing that works is
> to switch the PSU off, wait a few seconds, switch the PSU on again,
> and then press the mainboard's power button.
>
> Both the 32-bit and 64-bit 2.6.24-rc8 x86 kernels cause this problem,
> and it's 100% repeatable.
>
> I'll try to do some rc7->rc8 bisecting tomorrow.
I've now narrowed it down to the following change in 2.6.24-rc7-git5:
84cd2dfb04d23a961c5f537baa243fa54d0987ac
>sky2: remove check for PCI wakeup setting from BIOS
>
>The driver checks status of PCI power management to mark
>default setting of Wake On Lan. On some systems this works, but often
>it reports a that WOL is disabled when it isn't.
>
>This patch gets rid of that check and just reports the wake on
>lan status based on the hardware capablity.
>
>Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
>Signed-off-by: Jeff Garzik <[EMAIL PROTECTED]>
Reverting this eliminates the abovementioned BIOS hang.
I added a debug printk to sky2_init_netdev(), and it showed:
sky2_init_netdev: wol == 0x0, (sky2_wol_supported(hw) & WAKE_MAGIC) == 0x20
That is, 2.6.24-rc7-git4 and earlier drivers would set sky2->wol to 0,
while 2.6.24-rc7-git5 and newer will set it to 0x20. A quick look through
sky2.c shows that this will affect HW programming in several places.
Please revert or fix before 2.6.24 final.
lspci -vvxxx included below.
/Mikael
02:00.0 Ethernet controller: Marvell Technology Group Ltd. Unknown device 4364
(rev 12)
Subsystem: ASUSTeK Computer Inc. Unknown device 81f8
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size 08
Interrupt: pin A routed to IRQ 17
Region 0: Memory at ff9fc000 (64-bit, non-prefetchable) [size=16K]
Region 2: I/O ports at c800 [size=256]
Expansion ROM at ff9c0000 [disabled] [size=128K]
Capabilities: [48] Power Management version 3
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
Capabilities: [5c] Message Signalled Interrupts: 64bit+ Queue=0/0
Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [e0] Express Legacy Endpoint IRQ 0
Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
Device: Latency L0s unlimited, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s L1, Port 0
Link: Latency L0s <256ns, L1 unlimited
Link: ASPM Disabled RCB 128 bytes CommClk+ ExtSynch-
Link: Speed 2.5Gb/s, Width x1
00: ab 11 64 43 07 00 10 00 12 00 00 02 08 00 00 00
10: 04 c0 9f ff 00 00 00 00 01 c8 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 43 10 f8 81
30: 00 00 9c ff 48 00 00 00 00 00 00 00 0a 01 00 00
40: 00 00 f0 01 00 80 a0 01 01 50 03 fe 00 20 00 13
50: 03 5c 00 80 00 00 00 01 00 00 00 01 05 e0 80 00
60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
70: 00 02 00 00 00 00 00 00 00 00 00 00 00 00 00 00
80: 00 00 00 00 00 70 00 00 00 00 00 00 82 a8 e8 00
90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 10 00 11 00 c0 8f 00 00 00 20 19 00 11 ac 07 00
f0: 48 00 11 10 00 00 00 00 00 00 00 00 00 00 00 00
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
