On 100mbit versions, the driver always reports gigabit speed
available. The correct modes are already computed, then overwritten.

Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>


--- a/drivers/net/sky2.c        2007-09-19 09:18:50.000000000 -0700
+++ b/drivers/net/sky2.c        2007-09-19 09:19:35.000000000 -0700
@@ -2841,13 +2841,6 @@ static int sky2_get_settings(struct net_
        ecmd->supported = sky2_supported_modes(hw);
        ecmd->phy_address = PHY_ADDR_MARV;
        if (sky2_is_copper(hw)) {
-               ecmd->supported = SUPPORTED_10baseT_Half
-                   | SUPPORTED_10baseT_Full
-                   | SUPPORTED_100baseT_Half
-                   | SUPPORTED_100baseT_Full
-                   | SUPPORTED_1000baseT_Half
-                   | SUPPORTED_1000baseT_Full
-                   | SUPPORTED_Autoneg | SUPPORTED_TP;
                ecmd->port = PORT_TP;
                ecmd->speed = sky2->speed;
        } else {

-- 
Stephen Hemminger <[EMAIL PROTECTED]>

-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to