On 2021-04-07 7:50 p.m., Cong Wang wrote:
On Wed, Apr 7, 2021 at 8:36 AM Vlad Buslov <vla...@nvidia.com> wrote:

Action init code increments reference counter when it changes an action.
This is the desired behavior for cls API which needs to obtain action
reference for every classifier that points to action. However, act API just
needs to change the action and releases the reference before returning.
This sequence breaks when the requested action doesn't exist, which causes
act API init code to create new action with specified index, but action is
still released before returning and is deleted (unless it was referenced
concurrently by cls API).

Reproduction:

$ sudo tc actions ls action gact
$ sudo tc actions change action gact drop index 1
$ sudo tc actions ls action gact


I didn't know 'change' could actually create an action when
it does not exist. So it sets NLM_F_REPLACE, how could it
replace a non-existing one? Is this the right behavior or is it too
late to change even if it is not?

Thats expected behavior for "change" essentially mapping
to classical "SET" i.e.
"create if it doesnt exist, replace if it exists"
i.e NLM_F_CREATE | NLM_F_REPLACE

In retrospect, "replace" should probably have been just NLM_F_REPLACE
"replace if it exists, error otherwise".
Currently there is no distinction between the two.

"Add" is classical "CREATE" i.e "create if doesnt exist, otherwise
error"

It may be feasible to fix "replace" but not sure how many scripts over
the years are now dependent on that behavior.

cheers,
jamal

Reply via email to