On Mon, Apr 05, 2021 at 02:53:15PM +0200, Julian Labus wrote:
> Hi all,
>
> in our community mesh network we recently discovered that a TP-Link Archer
> C2600 device is unable to receive IPv6 UDP packets with a zero checksum when
> RX checksum offloading is enabled. The device uses ipq806x-gmac-dwmac for
> its ethernet ports.
>
> According to https://tools.ietf.org/html/rfc2460#section-8.1 this sounds
> like correct behavior as it says a UDP checksum must not be zero for IPv6
> packets. But this definition was relaxed in
> https://tools.ietf.org/html/rfc6935#section-5 to allow zero checksums in
> tunneling protocols like VXLAN where we discovered the problem.
>
> Can the behavior of the stmmac driver be changed to meet RFC6935 or would it
> be possible to make the (RX) Checksum Offloading Engine configurable via a
> device tree property to disable it in environments were it causes problems?
Hi Julian
I don't know the stmmac driver at all...
Have you played around with ethtool -k/-K? Can use this to turn off
hardware checksums?
I doubt a DT property would be accepted. What you probably want to do
is react on the NETDEV notifiers for when an upper interface is
changed. If a VXLAN interface is added, turn off hardware checksums.
Andrew
