On Thu, Mar 18, 2021 at 03:15:50PM +0100, Tobias Waldekranz wrote:
> These switches have two modes of classifying broadcast:
>
> 1. Broadcast is multicast.
> 2. Broadcast is its own unique thing that is always flooded
> everywhere.
>
> This driver uses the first option, making sure to load the broadcast
> address into all active databases. Because of this, we can support
> per-port broadcast flooding by (1) making sure to only set the subset
> of ports that have it enabled whenever joining a new bridge or VLAN,
> and (2) by updating all active databases whenever the setting is
> changed on a port.
>
> Signed-off-by: Tobias Waldekranz <[email protected]>
> ---
> drivers/net/dsa/mv88e6xxx/chip.c | 73 +++++++++++++++++++++++++++++++-
> 1 file changed, 72 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/net/dsa/mv88e6xxx/chip.c
> b/drivers/net/dsa/mv88e6xxx/chip.c
> index 7976fb699086..3baa4dadb0dd 100644
> --- a/drivers/net/dsa/mv88e6xxx/chip.c
> +++ b/drivers/net/dsa/mv88e6xxx/chip.c
> @@ -1982,6 +1982,21 @@ static int mv88e6xxx_broadcast_setup(struct
> mv88e6xxx_chip *chip, u16 vid)
> int err;
>
> for (port = 0; port < mv88e6xxx_num_ports(chip); port++) {
> + struct dsa_port *dp = dsa_to_port(chip->ds, port);
> + struct net_device *brport;
> +
> + if (dsa_is_unused_port(chip->ds, port))
> + continue;
> +
> + brport = dsa_port_to_bridge_port(dp);
> +
> + if (dp->bridge_dev &&
> + !br_port_flag_is_set(brport, BR_BCAST_FLOOD))
I think I would have liked to see a dsa_port_to_bridge_port helper that
actually returns NULL when dp->bridge_dev is NULL.
This would make your piece of code look as follows:
brport = dsa_port_to_bridge_port(dp);
if (brport && !br_port_flag_is_set(brport, BR_BCAST_FLOOD)
continue;
> + /* Skip bridged user ports where broadcast
> + * flooding is disabled.
> + */
> + continue;
> +
> err = mv88e6xxx_port_add_broadcast(chip, port, vid);
> if (err)
> return err;
