Fixes the following W=1 kernel build warning(s): drivers/net/usb/r8152.c:992: warning: Function parameter or member 'mode_pre' not described in 'fw_phy_nc' drivers/net/usb/r8152.c:992: warning: Function parameter or member 'mode_post' not described in 'fw_phy_nc'
Cc: "David S. Miller" <[email protected]> Cc: Jakub Kicinski <[email protected]> Cc: Hayes Wang <[email protected]> Cc: nic maintainers <[email protected]> Cc: [email protected] Cc: [email protected] Signed-off-by: Lee Jones <[email protected]> --- drivers/net/usb/r8152.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/usb/r8152.c b/drivers/net/usb/r8152.c index cebe2dc15c3f0..b9b3d19a2e988 100644 --- a/drivers/net/usb/r8152.c +++ b/drivers/net/usb/r8152.c @@ -963,8 +963,8 @@ struct fw_phy_patch_key { * @patch_en_addr: the register of enabling patch mode. Depends on chip. * @patch_en_value: patch mode enabled mask. Depends on the firmware. * @mode_reg: the regitster of switching the mode. - * @mod_pre: the mode needing to be set before loading the firmware. - * @mod_post: the mode to be set when finishing to load the firmware. + * @mode_pre: the mode needing to be set before loading the firmware. + * @mode_post: the mode to be set when finishing to load the firmware. * @reserved: reserved space (unused) * @bp_start: the start register of break points. Depends on chip. * @bp_num: the break point number which needs to be set for this firmware. -- 2.25.1
