Gentle Ping... @[email protected], Could you please help review patch 1/6 and 5/6 in this patch set?
Best Regards, Joakim Zhang > -----Original Message----- > From: Joakim Zhang <[email protected]> > Sent: 2020年10月21日 13:33 > To: [email protected]; [email protected]; [email protected]; > [email protected] > Cc: [email protected]; dl-linux-imx <[email protected]>; Ying Liu > <[email protected]>; [email protected]; [email protected]; > [email protected] > Subject: RE: [PATCH V4 0/6] can: flexcan: add stop mode support for i.MX8QM > > > > -----Original Message----- > > From: Joakim Zhang <[email protected]> > > Sent: 2020年10月21日 13:25 > > To: [email protected]; [email protected]; [email protected]; > > [email protected] > > Cc: [email protected]; dl-linux-imx <[email protected]>; Ying Liu > > <[email protected]>; [email protected]; > > [email protected]; [email protected] > > Subject: [PATCH V4 0/6] can: flexcan: add stop mode support for > > i.MX8QM > > > > The first patch from Liu Ying aims to export SCU symbols for SoCs w/wo > > SCU, so that no need to check CONFIG_IMX_SCU in the specific driver. > > > > The following patches are flexcan fixes and add stop mode support for > > i.MX8QM. > > Hi Shawnguo, > > Could you please help review patch 1/6 and 5/6? Since flexcan driver depends > on these. Thanks. > > For patch 1/6, it will benefit other drivers which cover SoCs w/wo SCU, such > as > i.MX Ethernet Controller driver (drivers/net/ethernet/freescale/fec_main.c). > > Best Regards, > Joakim Zhang
