On Thu, 2020-10-01 at 16:40 +0200, Frederic Weisbecker wrote:
> External Email
> 
> -------------------------------------------------------------------
> ---
> On Wed, Jul 22, 2020 at 02:49:49PM +0000, Alex Belits wrote:
> > +/**
> > + * task_isolation_kernel_enter() - clear low-level task isolation
> > flag
> > + *
> > + * This should be called immediately after entering kernel.
> > + */
> > +static inline void task_isolation_kernel_enter(void)
> > +{
> > +   unsigned long flags;
> > +
> > +   /*
> > +    * This function runs on a CPU that ran isolated task.
> > +    *
> > +    * We don't want this CPU running code from the rest of kernel
> > +    * until other CPUs know that it is no longer isolated.
> > +    * When CPU is running isolated task until this point anything
> > +    * that causes an interrupt on this CPU must end up calling
> > this
> > +    * before touching the rest of kernel. That is, this function
> > or
> > +    * fast_task_isolation_cpu_cleanup() or stop_isolation()
> > calling
> > +    * it. If any interrupt, including scheduling timer, arrives,
> > it
> > +    * will still end up here early after entering kernel.
> > +    * From this point interrupts are disabled until all CPUs will
> > see
> > +    * that this CPU is no longer running isolated task.
> > +    *
> > +    * See also fast_task_isolation_cpu_cleanup().
> > +    */
> > +   smp_rmb();
> 
> I'm a bit confused what this read memory barrier is ordering. Also
> against
> what it pairs.

My bad, I have kept it after there were left no write accesses from
other CPUs.

> 
> > +   if((this_cpu_read(ll_isol_flags) & FLAG_LL_TASK_ISOLATION) ==
> > 0)
> > +           return;
> > +
> > +   local_irq_save(flags);
> > +
> > +   /* Clear low-level flags */
> > +   this_cpu_write(ll_isol_flags, 0);
> > +
> > +   /*
> > +    * If something happened that requires a barrier that would
> > +    * otherwise be called from remote CPUs by CPU kick procedure,
> > +    * this barrier runs instead of it. After this barrier, CPU
> > +    * kick procedure would see the updated ll_isol_flags, so it
> > +    * will run its own IPI to trigger a barrier.
> > +    */
> > +   smp_mb();
> > +   /*
> > +    * Synchronize instructions -- this CPU was not kicked while
> > +    * in isolated mode, so it might require synchronization.
> > +    * There might be an IPI if kick procedure happened and
> > +    * ll_isol_flags was already updated while it assembled a CPU
> > +    * mask. However if this did not happen, synchronize everything
> > +    * here.
> > +    */
> > +   instr_sync();
> 
> It's the first time I meet an instruction barrier. I should get
> information
> about that but what is it ordering here?

Against barriers in instruction cache flushing (flush_icache_range()
and such). 

> > +   local_irq_restore(flags);
> > +}
> 
> Thanks.

Reply via email to