These changes were made while debugging the ksz9477 driver for use on a
custom board which uses the ksz9893 switch supported by this driver. The
patches have been runtime tested on top of Linux 5.8.4, I couldn't
runtime test them on top of 5.9-rc3 due to unrelated issues. They have
been build tested on top of net-next.
Changes from v1:
* Rebased onto net-next.
* Dropped unnecessary `#include <linux/printk.h>`.
* Instead of printing the phy mode in `ksz9477_port_setup()`, modify
the existing print in `ksz9477_config_cpu_port()` to always produce
output and to be more clear.
* Include Reviewed-by tag from v1 series so it isn't lost (is this
correct?).
Paul Barker (4):
net: dsa: microchip: Make switch detection more informative
net: dsa: microchip: Improve phy mode message
net: dsa: microchip: Disable RGMII in-band status on KSZ9893
net: dsa: microchip: Implement recommended reset timing
drivers/net/dsa/microchip/ksz9477.c | 25 ++++++++++++++++++++-----
drivers/net/dsa/microchip/ksz_common.c | 3 ++-
2 files changed, 22 insertions(+), 6 deletions(-)
--
2.28.0
