Chris Friesen <[EMAIL PROTECTED]> wrote:
[...]
>I have a ppc64 blade running a customized 2.6.10. At init time, two of
>our gigE links (eth4 and eth5) are bonded together to form bond0. This
>link has an MTU of 9000, and uses arp monitoring. We're using an ethernet
>driver with a modified RX path for jumbo frames[1]. With the stock
>driver, it seems to work fine.
2.6.10 is pretty old, and there have been a number of fixes to
the bonding ARP monitor since then, so it may be that it is simply
misbehaving (presuming that you're running the 2.6.10 bonding driver).
Are you in a position to test against a more recent kernel (and/or
bonding driver)? Does the miimon misbehave in a similar fashion?
>The problem is that eth5 seems to be bouncing up and down every 15 sec or
>so (see the attached log excerpt). Also, "ifconfig" shows that only 3
>packets totalling 250 bytes have gone out eth5, when I know that the arp
>monitoring code from the bond layer is sending 10 arps/sec out the link.
[...]
>Mar 29 20:54:08 base0-0-0-5-0-11-1 kernel: bonding: bond0: scheduling
>interface eth4 to be reset in 30000 msec.
[...]
>Mar 29 20:54:08 base0-0-0-5-0-11-1 kernel: bonding: bond0: cancelled scheduled
>reset of interface eth5
These two messages (which appear a number of times in your log
excerpt) are not from the standard mainline bonding driver, even in
2.6.10. I don't know what this is all about.
>If I boot the system and then log in and manually create the bond link
>(rather than it happening at init time) then I don't see the problem.
I would hazard to guess that it's an ARP monitor problem; older
versions of the ARP monitor had less than intelligent means to figure
out what the bond's IP address is (to use for the probes). This, along
with some logic problems in the monitor code itself, led to various
problems with the ARP probes and the sort of "up / down" cycle of
behavior you seem to be seeing.
-J
---
-Jay Vosburgh, IBM Linux Technology Center, [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
