[PATCH net-next 09/14] net: phylink: use config.an_enabled in ksettings_set method

[Russell King]

Rather than recomputing whether AN is enabled, use config.an_enabled.

Suggested-by: Ioana Ciornei <ioana.cior...@nxp.com>
Signed-off-by: Russell King <rmk+ker...@armlinux.org.uk>
---
 drivers/net/phy/phylink.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index 967c068d16c8..6cb9ca74341b 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -1400,8 +1400,7 @@ int phylink_ethtool_ksettings_set(struct phylink *pl,
        pl->link_config.interface = config.interface;
        pl->link_config.speed = config.speed;
        pl->link_config.duplex = config.duplex;
-       pl->link_config.an_enabled = kset->base.autoneg !=
-                                    AUTONEG_DISABLE;
+       pl->link_config.an_enabled = config.an_enabled;
 
        if (pl->cur_link_an_mode == MLO_AN_INBAND &&
            !test_bit(PHYLINK_DISABLE_STOPPED, &pl->phylink_disable_state)) {
-- 
2.20.1