[RFC PATCH 08/22] rpmsg: virtio_rpmsg_bus: Disable receive virtqueue callback when reading messages

[Kishon Vijay Abraham I]

Since rpmsg_recv_done() reads messages in a while loop, disable
callbacks until the while loop exits. This helps to get rid of the
annoying "uhm, incoming signal, but no used buffer ?" message.

Signed-off-by: Kishon Vijay Abraham I <kis...@ti.com>
---
 drivers/rpmsg/virtio_rpmsg_bus.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/rpmsg/virtio_rpmsg_bus.c b/drivers/rpmsg/virtio_rpmsg_bus.c
index 376ebbf880d6..2d0d42084ac0 100644
--- a/drivers/rpmsg/virtio_rpmsg_bus.c
+++ b/drivers/rpmsg/virtio_rpmsg_bus.c
@@ -777,6 +777,7 @@ static void rpmsg_recv_done(struct virtqueue *rvq)
                return;
        }
 
+       virtqueue_disable_cb(rvq);
        while (msg) {
                err = rpmsg_recv_single(vrp, dev, msg, len);
                if (err)
@@ -786,6 +787,19 @@ static void rpmsg_recv_done(struct virtqueue *rvq)
 
                msg = virtqueue_get_buf(rvq, &len);
        }
+       virtqueue_enable_cb(rvq);
+
+       /*
+        * Try to read message one more time in case a new message is submitted
+        * after virtqueue_get_buf() inside the while loop but before enabling
+        * callbacks
+        */
+       msg = virtqueue_get_buf(rvq, &len);
+       if (msg) {
+               err = rpmsg_recv_single(vrp, dev, msg, len);
+               if (!err)
+                       msgs_received++;
+       }
 
        dev_dbg(dev, "Received %u messages\n", msgs_received);
 
-- 
2.17.1