From: Heiko Stuebner <heiko.stueb...@theobroma-systems.com>
At least VSC8530/8531/8540/8541 contain a clock output that can emit
a predefined rate of 25, 50 or 125MHz.
This may then feed back into the network interface as source clock.
So expose a clock-provider from the phy using the common clock framework
to allow setting the rate.
Signed-off-by: Heiko Stuebner <heiko.stueb...@theobroma-systems.com>
---
drivers/net/phy/mscc/mscc.h | 13 +++
drivers/net/phy/mscc/mscc_main.c | 182 +++++++++++++++++++++++++++++--
2 files changed, 187 insertions(+), 8 deletions(-)
diff --git a/drivers/net/phy/mscc/mscc.h b/drivers/net/phy/mscc/mscc.h
index fbcee5fce7b2..94883dab5cc1 100644
--- a/drivers/net/phy/mscc/mscc.h
+++ b/drivers/net/phy/mscc/mscc.h
@@ -218,6 +218,13 @@ enum rgmii_clock_delay {
#define INT_MEM_DATA_M 0x00ff
#define INT_MEM_DATA(x) (INT_MEM_DATA_M & (x))
+#define MSCC_CLKOUT_CNTL 13
+#define CLKOUT_ENABLE BIT(15)
+#define CLKOUT_FREQ_MASK GENMASK(14, 13)
+#define CLKOUT_FREQ_25M (0x0 << 13)
+#define CLKOUT_FREQ_50M (0x1 << 13)
+#define CLKOUT_FREQ_125M (0x2 << 13)
+
#define MSCC_PHY_PROC_CMD 18
#define PROC_CMD_NCOMPLETED 0x8000
#define PROC_CMD_FAILED 0x4000
@@ -360,6 +367,12 @@ struct vsc8531_private {
*/
unsigned int base_addr;
+#ifdef CONFIG_COMMON_CLK
+ struct clk_hw clkout_hw;
+#endif
+ u32 clkout_rate;
+ int clkout_enabled;
+
#if IS_ENABLED(CONFIG_MACSEC)
/* MACsec fields:
* - One SecY per device (enforced at the s/w implementation level)
diff --git a/drivers/net/phy/mscc/mscc_main.c b/drivers/net/phy/mscc/mscc_main.c
index 5d2777522fb4..727a9dd58403 100644
--- a/drivers/net/phy/mscc/mscc_main.c
+++ b/drivers/net/phy/mscc/mscc_main.c
@@ -7,6 +7,7 @@
* Copyright (c) 2016 Microsemi Corporation
*/
+#include <linux/clk-provider.h>
#include <linux/firmware.h>
#include <linux/jiffies.h>
#include <linux/kernel.h>
@@ -431,7 +432,6 @@ static int vsc85xx_dt_led_mode_get(struct phy_device
*phydev,
return led_mode;
}
-
#else
static int vsc85xx_edge_rate_magic_get(struct phy_device *phydev)
{
@@ -1508,6 +1508,43 @@ static int vsc85xx_config_init(struct phy_device *phydev)
return 0;
}
+static int vsc8531_config_init(struct phy_device *phydev)
+{
+ struct vsc8531_private *vsc8531 = phydev->priv;
+ u16 val;
+ int rc;
+
+ rc = vsc85xx_config_init(phydev);
+ if (rc)
+ return rc;
+
+#ifdef CONFIG_COMMON_CLK
+ switch (vsc8531->clkout_rate) {
+ case 25000000:
+ val = CLKOUT_FREQ_25M;
+ break;
+ case 50000000:
+ val = CLKOUT_FREQ_50M;
+ break;
+ case 125000000:
+ val = CLKOUT_FREQ_125M;
+ break;
+ default:
+ return -EINVAL;
+ }
+
+ if (vsc8531->clkout_enabled)
+ val |= CLKOUT_ENABLE;
+
+ rc = phy_write_paged(phydev, MSCC_PHY_PAGE_EXTENDED_GPIO,
+ MSCC_CLKOUT_CNTL, val);
+ if (rc)
+ return rc;
+#endif
+
+ return 0;
+}
+
static int vsc8584_did_interrupt(struct phy_device *phydev)
{
int rc = 0;
@@ -1935,6 +1972,107 @@ static int vsc85xx_read_status(struct phy_device
*phydev)
return genphy_read_status(phydev);
}
+#ifdef CONFIG_COMMON_CLK
+#define clkout_hw_to_vsc8531(_hw) container_of(_hw, struct vsc8531_private,
clkout_hw)
+
+static int clkout_rates[] = {
+ 125000000,
+ 50000000,
+ 25000000,
+};
+
+static unsigned long vsc8531_clkout_recalc_rate(struct clk_hw *hw,
+ unsigned long parent_rate)
+{
+ struct vsc8531_private *vsc8531 = clkout_hw_to_vsc8531(hw);
+
+ return vsc8531->clkout_rate;
+}
+
+static long vsc8531_clkout_round_rate(struct clk_hw *hw, unsigned long rate,
+ unsigned long *prate)
+{
+ int i;
+
+ for (i = 0; i < ARRAY_SIZE(clkout_rates); i++)
+ if (clkout_rates[i] <= rate)
+ return clkout_rates[i];
+ return 0;
+}
+
+static int vsc8531_clkout_set_rate(struct clk_hw *hw, unsigned long rate,
+ unsigned long parent_rate)
+{
+ struct vsc8531_private *vsc8531 = clkout_hw_to_vsc8531(hw);
+
+ vsc8531->clkout_rate = rate;
+ return 0;
+}
+
+static int vsc8531_clkout_prepare(struct clk_hw *hw)
+{
+ struct vsc8531_private *vsc8531 = clkout_hw_to_vsc8531(hw);
+
+ vsc8531->clkout_enabled = true;
+ return 0;
+}
+
+static void vsc8531_clkout_unprepare(struct clk_hw *hw)
+{
+ struct vsc8531_private *vsc8531 = clkout_hw_to_vsc8531(hw);
+
+ vsc8531->clkout_enabled = false;
+}
+
+static int vsc8531_clkout_is_prepared(struct clk_hw *hw)
+{
+ struct vsc8531_private *vsc8531 = clkout_hw_to_vsc8531(hw);
+
+ return vsc8531->clkout_enabled;
+}
+
+static const struct clk_ops vsc8531_clkout_ops = {
+ .prepare = vsc8531_clkout_prepare,
+ .unprepare = vsc8531_clkout_unprepare,
+ .is_prepared = vsc8531_clkout_is_prepared,
+ .recalc_rate = vsc8531_clkout_recalc_rate,
+ .round_rate = vsc8531_clkout_round_rate,
+ .set_rate = vsc8531_clkout_set_rate,
+};
+
+static int vsc8531_register_clkout(struct phy_device *phydev)
+{
+ struct vsc8531_private *vsc8531 = phydev->priv;
+ struct device *dev = &phydev->mdio.dev;
+ struct device_node *of_node = dev->of_node;
+ struct clk_init_data init;
+ int ret;
+
+ init.name = "vsc8531-clkout";
+ init.ops = &vsc8531_clkout_ops;
+ init.flags = 0;
+ init.parent_names = NULL;
+ init.num_parents = 0;
+ vsc8531->clkout_hw.init = &init;
+
+ /* optional override of the clockname */
+ of_property_read_string(of_node, "clock-output-names", &init.name);
+
+ /* register the clock */
+ ret = devm_clk_hw_register(dev, &vsc8531->clkout_hw);
+ if (!ret)
+ ret = devm_of_clk_add_hw_provider(dev, of_clk_hw_simple_get,
+ &vsc8531->clkout_hw);
+
+ return ret;
+}
+#else
+static int vsc8531_register_clkout(struct phy_device *phydev)
+{
+ return 0;
+}
+#endif
+
static int vsc85xx_probe_helper(struct phy_device *phydev,
u32 *leds, int num_leds, u16 led_modes,
const struct vsc85xx_hw_stat *stats, int nstats)
@@ -1981,6 +2119,34 @@ static int vsc8514_probe(struct phy_device *phydev)
vsc8531->base_addr, 0);
}
+static int vsc8531_probe(struct phy_device *phydev)
+{
+ struct vsc8531_private *vsc8531;
+ int rate_magic, rc;
+ u32 default_mode[2] = {VSC8531_LINK_1000_ACTIVITY,
+ VSC8531_LINK_100_ACTIVITY};
+
+ rate_magic = vsc85xx_edge_rate_magic_get(phydev);
+ if (rate_magic < 0)
+ return rate_magic;
+
+ rc = vsc85xx_probe_helper(phydev, default_mode,
+ ARRAY_SIZE(default_mode),
+ VSC85XX_SUPP_LED_MODES,
+ vsc85xx_hw_stats,
+ ARRAY_SIZE(vsc85xx_hw_stats));
+ if (rc < 0)
+ return rc;
+
+ vsc8531 = phydev->priv;
+ vsc8531->rate_magic = rate_magic;
+ rc = vsc8531_register_clkout(phydev);
+ if (rc < 0)
+ return rc;
+
+ return 0;
+}
+
static int vsc8574_probe(struct phy_device *phydev)
{
struct vsc8531_private *vsc8531;
@@ -2136,14 +2302,14 @@ static struct phy_driver vsc85xx_driver[] = {
.phy_id_mask = 0xfffffff0,
/* PHY_BASIC_FEATURES */
.soft_reset = &genphy_soft_reset,
- .config_init = &vsc85xx_config_init,
+ .config_init = &vsc8531_config_init,
.config_aneg = &vsc85xx_config_aneg,
.read_status = &vsc85xx_read_status,
.ack_interrupt = &vsc85xx_ack_interrupt,
.config_intr = &vsc85xx_config_intr,
.suspend = &genphy_suspend,
.resume = &genphy_resume,
- .probe = &vsc85xx_probe,
+ .probe = &vsc8531_probe,
.set_wol = &vsc85xx_wol_set,
.get_wol = &vsc85xx_wol_get,
.get_tunable = &vsc85xx_get_tunable,
@@ -2160,14 +2326,14 @@ static struct phy_driver vsc85xx_driver[] = {
.phy_id_mask = 0xfffffff0,
/* PHY_GBIT_FEATURES */
.soft_reset = &genphy_soft_reset,
- .config_init = &vsc85xx_config_init,
+ .config_init = &vsc8531_config_init,
.config_aneg = &vsc85xx_config_aneg,
.read_status = &vsc85xx_read_status,
.ack_interrupt = &vsc85xx_ack_interrupt,
.config_intr = &vsc85xx_config_intr,
.suspend = &genphy_suspend,
.resume = &genphy_resume,
- .probe = &vsc85xx_probe,
+ .probe = &vsc8531_probe,
.set_wol = &vsc85xx_wol_set,
.get_wol = &vsc85xx_wol_get,
.get_tunable = &vsc85xx_get_tunable,
@@ -2184,14 +2350,14 @@ static struct phy_driver vsc85xx_driver[] = {
.phy_id_mask = 0xfffffff0,
/* PHY_BASIC_FEATURES */
.soft_reset = &genphy_soft_reset,
- .config_init = &vsc85xx_config_init,
+ .config_init = &vsc8531_config_init,
.config_aneg = &vsc85xx_config_aneg,
.read_status = &vsc85xx_read_status,
.ack_interrupt = &vsc85xx_ack_interrupt,
.config_intr = &vsc85xx_config_intr,
.suspend = &genphy_suspend,
.resume = &genphy_resume,
- .probe = &vsc85xx_probe,
+ .probe = &vsc8531_probe,
.set_wol = &vsc85xx_wol_set,
.get_wol = &vsc85xx_wol_get,
.get_tunable = &vsc85xx_get_tunable,
@@ -2208,7 +2374,7 @@ static struct phy_driver vsc85xx_driver[] = {
.phy_id_mask = 0xfffffff0,
/* PHY_GBIT_FEATURES */
.soft_reset = &genphy_soft_reset,
- .config_init = &vsc85xx_config_init,
+ .config_init = &vsc8531_config_init,
.config_aneg = &vsc85xx_config_aneg,
.read_status = &vsc85xx_read_status,
.ack_interrupt = &vsc85xx_ack_interrupt,
--
2.26.2
