Rob
On 5/29/20 1:25 PM, Rob Herring wrote:
On Wed, May 27, 2020 at 11:49:31AM -0500, Dan Murphy wrote:
tx-internal-delays and rx-internal-delays are a common setting for RGMII
capable devices.
These properties are used when the phy-mode or phy-controller is set to
rgmii-id, rgmii-rxid or rgmii-txid. These modes indicate to the
controller that the PHY will add the internal delay for the connection.
Signed-off-by: Dan Murphy <dmur...@ti.com>
---
.../bindings/net/ethernet-controller.yaml | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-controller.yaml
b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
index ac471b60ed6a..70702a4ef5e8 100644
--- a/Documentation/devicetree/bindings/net/ethernet-controller.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
@@ -143,6 +143,20 @@ properties:
Specifies the PHY management type. If auto is set and fixed-link
is not specified, it uses MDIO for management.
+ rx-internal-delay-ps:
+ $ref: /schemas/types.yaml#definitions/uint32
+ description: |
+ RGMII Receive PHY Clock Delay defined in pico seconds. This is used for
+ PHY's that have configurable RX internal delays. This property is only
+ used when the phy-mode or phy-connection-type is rgmii-id or rgmii-rxid.
Isn't this a property of the phy (this is the controller schema)? Looks
like we have similar properties already and they go in phy nodes. Would
be good to have a standard property, but let's be clear where it goes.
We need to add '-ps' as a standard unit suffix (in dt-schema) and then a
type is not needed here.
This is a PHY specific property.
I will move them.
Dumb question but you can just point me to the manual about how and
where to add the '-ps' to the dt-schema
Dan
Rob
