The caller doesn't care about the error codes, they only check for zero vs non-zero. Still, it's better to preserve the negative error codes from alloc_uld_rxqs() instead of changing it to 1. We can also return directly if there is a failure.
Signed-off-by: Dan Carpenter <[email protected]> --- This isn't a bugfix so it should probably go to net-next, but the code is pretty old. The other error handling only checks the last iteration in the for_each_port() loop. I didn't change that because it's slightly riskier and I can't test the code. drivers/net/ethernet/chelsio/cxgb4/cxgb4_uld.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_uld.c b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_uld.c index 6b1d3df4b9bae..9e3c6b36cde89 100644 --- a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_uld.c +++ b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_uld.c @@ -174,13 +174,14 @@ static int setup_sge_queues_uld(struct adapter *adap, unsigned int uld_type, bool lro) { struct sge_uld_rxq_info *rxq_info = adap->sge.uld_rxq_info[uld_type]; - int i, ret = 0; + int i, ret; - ret = !(!alloc_uld_rxqs(adap, rxq_info, lro)); + ret = alloc_uld_rxqs(adap, rxq_info, lro); + if (ret) + return ret; /* Tell uP to route control queue completions to rdma rspq */ - if (adap->flags & CXGB4_FULL_INIT_DONE && - !ret && uld_type == CXGB4_ULD_RDMA) { + if (adap->flags & CXGB4_FULL_INIT_DONE && uld_type == CXGB4_ULD_RDMA) { struct sge *s = &adap->sge; unsigned int cmplqid; u32 param, cmdop; -- 2.26.2
