From: Andrew Lunn <[email protected]> Sent: Thursday, May 21, 2020 1:03 AM
> On Wed, May 20, 2020 at 04:31:55PM +0800, [email protected] wrote:
> > From: Fugang Duan <[email protected]>
> >
> > Update the gpr property to define gpr register offset and bit in DT.
> >
> > Signed-off-by: Fugang Duan <[email protected]>
> > ---
> > arch/arm/boot/dts/imx6qdl.dtsi | 2 +-
> > 1 file changed, 1 insertion(+), 1 deletion(-)
> >
> > diff --git a/arch/arm/boot/dts/imx6qdl.dtsi
> > b/arch/arm/boot/dts/imx6qdl.dtsi index 98da446..a4a68b7 100644
> > --- a/arch/arm/boot/dts/imx6qdl.dtsi
> > +++ b/arch/arm/boot/dts/imx6qdl.dtsi
> > @@ -1045,7 +1045,7 @@
> > <&clks
> IMX6QDL_CLK_ENET>,
> > <&clks
> IMX6QDL_CLK_ENET_REF>;
> > clock-names = "ipg", "ahb", "ptp";
> > - gpr = <&gpr>;
> > + gpr = <&gpr 0x34 27>;
> > status = "disabled";
> > };
>
> Hi Andy
>
> This is the same values as hard coded, so no change here.
>
> The next patch does not use grp at all. So it is unclear to me if you actually
> make use of what you just added. I don't see anywhere
>
> gpr = <&gpr 0x42 24>;
>
> which is the whole point of this change, being able to specify different
> values.
>
> Andrew
Andrew, patch#1 in the series will parse the property to get register offset
and bit.
Patch#2 describes the property format as below:
<&gpr req_gpr req_bit>.
gpr is the phandle to general purpose register node.
req_gpr is the gpr register offset for ENET stop request.
req_bit is the gpr bit offset for ENET stop request.
All i.MX support wake-on-lan, imx6q/dl/qp is the first platforms in upstream to
support it.
As you know, most of i.MX chips has two ethernet instances, they have different
gpr bit.
gpr is used to enter/exit stop mode for soc. So it can be defined in dtsi file.
"fsl,magic-packet;" property is define the board wakeup capability.
I am not sure whether above information is clear for you why to add the patch
set.
Andy
