On Fri, May 08, 2020 at 05:48:33PM -0500, Jeremy Linton wrote: > Hi, > > On 5/8/20 3:27 PM, Andrew Lunn wrote: > > > > There is a very small number of devices where the vendor messed up, > > > > and did not put valid contents in the ID registers. In such cases, we > > > > can read the IDs from device tree. These are then used in exactly the > > > > same way as if they were read from the device. > > > > > > > > > > Is that the case here? > > > > Sorry, I don't understand the question? > > I was asking in general, does this machine report the ID's correctly. More > directed at Calvin, but part of it is the board vendor too. So I suspect no > one can really answer "yes", despite that seeming to be the case.
I had tested RGMII PHYs(AR8035) with c22 using mdiobus_register. Vendor ID was read out correctly while autoprobing. AQR107(c45) PHYs that were connected gave back 0x00. This is expected because the MDIO bus is configured to talk c22. Regards Calvin
