On Tue, Oct 08, 2019 at 10:56:59AM +0000, Igor Russkikh wrote:
> From: Dmitry Bezrukov <[email protected]>
>
> Depending on FW configuration we can manage from 0 to 3 PINs for periodic
> output
> and from 0 to 1 ext ts PIN for getting TS for external event.
>
> Ext TS PIN functionality is implemented via periodic timestamps polling
> directly from PHY, because right now there is now way to received
> PIN trigger interrupt from phy.
Hi Igor
Is that a hardware limitation? Is the PHY interrupt not connected at
all? Could future cards have the interrupt connected?
> +static int aq_ptp_hw_pin_conf(struct aq_nic_s *aq_nic, u32 pin_index, u64
> start,
> + u64 period)
> +{
> + if (period)
> + netdev_info(aq_nic->ndev,
> + "Enable GPIO %d pulsing, start time %llu, period
> %u\n",
> + pin_index, start, (u32)period);
> + else
> + netdev_info(aq_nic->ndev,
> + "Disable GPIO %d pulsing, start time %llu, period
> %u\n",
> + pin_index, start, (u32)period);
_info is too high a log level. _dbg would be better..
> +
> + /* Notify hardware of request to being sending pulses.
> + * If period is ZERO then pulsen is disabled.
> + */
> + mutex_lock(&aq_nic->fwreq_mutex);
> + aq_nic->aq_hw_ops->hw_gpio_pulse(aq_nic->aq_hw, pin_index,
> + start, (u32)period);
> + mutex_unlock(&aq_nic->fwreq_mutex);
> +
> + return 0;
> +}
> +
> +static int aq_ptp_perout_pin_configure(struct ptp_clock_info *ptp,
> + struct ptp_clock_request *rq, int on)
> +{
> + struct aq_ptp_s *aq_ptp = container_of(ptp, struct aq_ptp_s, ptp_info);
> + struct ptp_clock_time *t = &rq->perout.period;
> + struct ptp_clock_time *s = &rq->perout.start;
> + struct aq_nic_s *aq_nic = aq_ptp->aq_nic;
> + u64 start, period;
> + u32 pin_index = rq->perout.index;
> +
> + /* verify the request channel is there */
> + if (pin_index >= ptp->n_per_out)
> + return -EINVAL;
> +
> + /* we cannot support periods greater
> + * than 4 seconds due to reg limit
> + */
> + if (t->sec > 4 || t->sec < 0)
> + return -ERANGE;
> +
> + /* convert to unsigned 64b ns,
> + * verify we can put it in a 32b register
> + */
> + period = on ? t->sec * NSEC_PER_SEC + t->nsec : 0;
> +
> + /* verify the value is in range supported by hardware */
> + if (period > U32_MAX)
> + return -ERANGE;
What is U32_MAX ns? Is it greater than 4 seconds?
Andrew
