On Wed, Aug 21, 2019 at 04:43:35PM +0200, René van Dorst wrote: > + if (MTK_HAS_CAPS(mac->hw->soc->caps, MTK_SGMII)) { > + if (state->interface != PHY_INTERFACE_MODE_2500BASEX) { > phylink_set(mask, 1000baseT_Full); > phylink_set(mask, 1000baseX_Full); > + } else { > + phylink_set(mask, 2500baseT_Full); > + phylink_set(mask, 2500baseX_Full); > + }
If you can dynamically switch between 1000BASE-X and 2500BASE-X, then you need to have both set. See mvneta.c: if (pp->comphy || state->interface != PHY_INTERFACE_MODE_2500BASEX) { phylink_set(mask, 1000baseT_Full); phylink_set(mask, 1000baseX_Full); } if (pp->comphy || state->interface == PHY_INTERFACE_MODE_2500BASEX) { phylink_set(mask, 2500baseT_Full); phylink_set(mask, 2500baseX_Full); } What this is saying is, if we have a comphy (which is the serdes lane facing component, where the data rate is setup) then we can support both speeds (and so mask ends up with all four bits set.) Otherwise, we only support a single-speed (1000Gbps for non-2500BASE-X etc.) > + } else { > + if (state->interface == PHY_INTERFACE_MODE_TRGMII) { > + phylink_set(mask, 1000baseT_Full); > + } else { > + phylink_set(mask, 10baseT_Half); > + phylink_set(mask, 10baseT_Full); > + phylink_set(mask, 100baseT_Half); > + phylink_set(mask, 100baseT_Full); > + > + if (state->interface != PHY_INTERFACE_MODE_MII) { > + phylink_set(mask, 1000baseT_Half); > + phylink_set(mask, 1000baseT_Full); > + phylink_set(mask, 1000baseX_Full); > + } I'm also wondering about the "MTK_HAS_CAPS(mac->hw->soc->caps, MTK_SGMII)" above. (Here comes a reason why using SGMII to cover all single-lane serdes modes causes confusion - unfortunately, some folk use SGMII to describe all these modes. So, I'm going to use the terminology "Cisco SGMII" to mean exactly the SGMII format published by Cisco, "802.3 1000BASE-X" to mean the original IEEE 802.3 format running at 1.25Gbps, and "up-clocked 2500BASE-X" to mean the 3.125Gbps version of the 802.3 1000BASE-X protocol.) Isn't this set for Cisco SGMII as well as for 802.3 1000BASE-X and the up-clocked 2500BASE-X modes? If so, is there a reason why 10Mbps and 100Mbps speeds aren't supported on Cisco SGMII links? -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up According to speedtest.net: 11.9Mbps down 500kbps up