Hi Marc,
Kindly pinging...
After you git pull request for linux-can-next-for-5.4-20190724, some patches
are missing from linux-can-next/testing.
can: flexcan: flexcan_mailbox_read() make use of flexcan_write64() to mark the
mailbox as read
can: flexcan: flexcan_irq(): add support for TX mailbox in iflag1
can: flexcan: flexcan_read_reg_iflag_rx(): optimize reading
can: flexcan: introduce struct flexcan_priv::tx_mask and make use of it
can: flexcan: convert struct flexcan_priv::rx_mask{1,2} to rx_mask
can: flexcan: remove TX mailbox bit from struct flexcan_priv::rx_mask{1,2}
can: flexcan: rename struct flexcan_priv::reg_imask{1,2}_default to rx_mask{1,2}
can: flexcan: flexcan_irq(): rename variable reg_iflag -> reg_iflag_rx
can: flexcan: rename macro FLEXCAN_IFLAG_MB() -> FLEXCAN_IFLAG2_MB()
You can refer to below link for the reason of adding above patches:
https://www.spinics.net/lists/linux-can/msg00777.html
https://www.spinics.net/lists/linux-can/msg01150.html
Are you prepared to add back these patches as they are necessary for Flexcan
CAN FD? And this Flexcan CAN FD patch set is based on these patches.
Thanks a lot!
Best Regards,
Joakim Zhang
> -----Original Message-----
> From: Joakim Zhang
> Sent: 2019年7月12日 16:03
> To: m...@pengutronix.de; linux-...@vger.kernel.org
> Cc: w...@grandegger.com; dl-linux-imx <linux-...@nxp.com>;
> netdev@vger.kernel.org; Joakim Zhang <qiangqing.zh...@nxp.com>
> Subject: [PATCH 0/8] can: flexcan: add CAN FD support for NXP Flexcan
>
> Hi Marc,
>
> This patch set intends to add support for NXP Flexcan CAN FD, it has been
> validated on three NXP platform(i.MX8QM/QXP, S32V234, LX2160AR1).
> After discussed with another two Fexcan owner, we sorted out this version.
>
> I hope you can pick up the patch set as it can fully meet requirement of above
> three platform. And after that, we can start to do upstream about CAN FD.
>
> Thanks a lot!
>
> BRs,
> Joakim Zhang
>
> Joakim Zhang (8):
> can: flexcan: allocate skb in flexcan_mailbox_read
> can: flexcan: use struct canfd_frame for CAN classic frame
> can: flexcan: add CAN FD mode support
> can: flexcan: add CANFD BRS support
> can: flexcan: add ISO CAN FD feature support
> can: flexcan: add Transceiver Delay Compensation suopport
> can: flexcan: add imx8qm support
> can: flexcan: add lx2160ar1 support
>
> drivers/net/can/flexcan.c | 340 ++++++++++++++++++++++++++++-----
> drivers/net/can/rx-offload.c | 33 +---
> include/linux/can/rx-offload.h | 5 +-
> 3 files changed, 305 insertions(+), 73 deletions(-)
>
> --
> 2.17.1
