Hello,
This series introduces the PTP Hardware Clock (PHC) support to the Mscc
Ocelot switch driver. In order to make use of this, a new register bank
is added and described in the device tree, as well as a new interrupt.
The use this bank and interrupt was made optional in the driver for dt
compatibility reasons.
Patches 2 and 4 should probably go through the MIPS tree.
Thanks!
Antoine
Since v1:
- Used list_for_each_safe() in ocelot_deinit().
- Fixed a memory leak in ocelot_deinit() by calling
dev_kfree_skb_any().
- Fixed a locking issue in get_hwtimestamp().
- Handled the NULL case of ptp_clock_register().
- Added comments on optional dt properties.
Antoine Tenart (8):
Documentation/bindings: net: ocelot: document the PTP bank
MIPS: dts: mscc: describe the PTP register range
Documentation/bindings: net: ocelot: document the PTP ready IRQ
MIPS: dts: mscc: describe the PTP ready interrupt
net: mscc: describe the PTP register range
net: mscc: improve the frame header parsing readability
net: mscc: remove the frame_info cpuq member
net: mscc: PTP Hardware Clock (PHC) support
.../devicetree/bindings/net/mscc-ocelot.txt | 20 +-
arch/mips/boot/dts/mscc/ocelot.dtsi | 7 +-
drivers/net/ethernet/mscc/ocelot.c | 393 +++++++++++++++++-
drivers/net/ethernet/mscc/ocelot.h | 47 ++-
drivers/net/ethernet/mscc/ocelot_board.c | 139 ++++++-
drivers/net/ethernet/mscc/ocelot_ptp.h | 41 ++
drivers/net/ethernet/mscc/ocelot_regs.c | 11 +
7 files changed, 626 insertions(+), 32 deletions(-)
create mode 100644 drivers/net/ethernet/mscc/ocelot_ptp.h
--
2.21.0
