Subject: e1000: Fix Wake-on-Lan with forced gigabit speed
From: Jesse Brandeburg <[EMAIL PROTECTED]>
If the user has forced gigabit speed, phy power management must be disabled;
otherwise the NIC would try to negotiate to a linkspeed of 10/100 mbit on
shutdown, which would lead to a total loss of link. This loss of link breaks
Wake-on-Lan and IPMI.
Signed-off-by: Jesse Brandeburg <[EMAIL PROTECTED]>
Signed-off-by: Auke Kok <[EMAIL PROTECTED]>
Signed-off-by: Arjan van de Ven <[EMAIL PROTECTED]>
---
drivers/net/e1000/e1000_main.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
Index: linux-2.6/drivers/net/e1000/e1000_main.c
===================================================================
--- linux-2.6.orig/drivers/net/e1000/e1000_main.c
+++ linux-2.6/drivers/net/e1000/e1000_main.c
@@ -732,6 +732,20 @@ e1000_reset(struct e1000_adapter *adapte
if (e1000_init_hw(&adapter->hw))
DPRINTK(PROBE, ERR, "Hardware Error\n");
e1000_update_mng_vlan(adapter);
+
+ /* if (adapter->hwflags & HWFLAGS_PHY_PWR_BIT) { */
+ if (adapter->hw.mac_type >= e1000_82544 &&
+ adapter->hw.mac_type <= e1000_82547_rev_2 &&
+ adapter->hw.autoneg == 1 &&
+ adapter->hw.autoneg_advertised == ADVERTISE_1000_FULL) {
+ uint32_t ctrl = E1000_READ_REG(&adapter->hw, CTRL);
+ /* clear phy power management bit if we are in gig only mode,
+ * which if enabled will attempt negotiation to 100Mb, which
+ * can cause a loss of link at power off or driver unload */
+ ctrl &= ~E1000_CTRL_SWDPIN3;
+ E1000_WRITE_REG(&adapter->hw, CTRL, ctrl);
+ }
+
/* Enable h/w to recognize an 802.1Q VLAN Ethernet packet */
E1000_WRITE_REG(&adapter->hw, VET, ETHERNET_IEEE_VLAN_TYPE);
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
