I would rather fix Andy's problem by not clearing
multicast information on link down.
Also, add code to restore multicast state after ethtool phy reset.
Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
---
drivers/net/skge.c | 5 ++---
1 files changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/net/skge.c b/drivers/net/skge.c
index b294903..010fc65 100644
--- a/drivers/net/skge.c
+++ b/drivers/net/skge.c
@@ -2154,8 +2154,6 @@ static void yukon_link_down(struct skge_
int port = skge->port;
u16 ctrl;
- gm_phy_write(hw, port, PHY_MARV_INT_MASK, 0);
-
ctrl = gma_read16(hw, port, GM_GP_CTRL);
ctrl &= ~(GM_GPCR_RX_ENA | GM_GPCR_TX_ENA);
gma_write16(hw, port, GM_GP_CTRL, ctrl);
@@ -2167,7 +2165,6 @@ static void yukon_link_down(struct skge_
gm_phy_write(hw, port, PHY_MARV_AUNE_ADV, ctrl);
}
- yukon_reset(hw, port);
skge_link_down(skge);
yukon_init(hw, port);
@@ -2268,6 +2265,8 @@ static void skge_phy_reset(struct skge_p
yukon_init(hw, port);
}
mutex_unlock(&hw->phy_mutex);
+
+ dev->set_multicast_list(dev);
}
/* Basic MII support */
--
1.4.1
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
