RTL8211C has an issue when operating in Gigabit slave mode, therefore
genphy driver can't be used. See also this U-boot change.
https://lists.denx.de/pipermail/u-boot/2016-March/249712.html
Add a PHY driver for this chip with the quirk to force Gigabit master
mode. As a note: This will make it impossible to connect two network
ports directly which both are driven by a RTl8211C.
Signed-off-by: Heiner Kallweit <hkallwe...@gmail.com>
---
drivers/net/phy/realtek.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
index 082fb40c..eb6cb2cc 100644
--- a/drivers/net/phy/realtek.c
+++ b/drivers/net/phy/realtek.c
@@ -128,6 +128,15 @@ static int rtl8211f_config_intr(struct phy_device *phydev)
return phy_write_paged(phydev, 0xa42, RTL821x_INER, val);
}
+static int rtl8211c_config_init(struct phy_device *phydev)
+{
+ /* RTL8211C has an issue when operating in Gigabit slave mode */
+ phy_set_bits(phydev, MII_CTRL1000,
+ CTL1000_ENABLE_MASTER | CTL1000_AS_MASTER);
+
+ return genphy_config_init(phydev);
+}
+
static int rtl8211f_config_init(struct phy_device *phydev)
{
int ret;
@@ -190,6 +199,14 @@ static struct phy_driver realtek_drvs[] = {
.write_mmd = &genphy_write_mmd_unsupported,
.suspend = rtl8211b_suspend,
.resume = rtl8211b_resume,
+ }, {
+ .phy_id = 0x001cc913,
+ .name = "RTL8211C Gigabit Ethernet",
+ .phy_id_mask = 0x001fffff,
+ .features = PHY_GBIT_FEATURES,
+ .config_init = rtl8211c_config_init,
+ .read_mmd = &genphy_read_mmd_unsupported,
+ .write_mmd = &genphy_write_mmd_unsupported,
}, {
.phy_id = 0x001cc914,
.name = "RTL8211DN Gigabit Ethernet",
--
2.18.0
