On 05/14/2018 01:04 PM, Alexandre Belloni wrote:
> Add a driver for the Microsemi MII Management controller (MIIM) found on
> Microsemi SoCs.
> On Ocelot, there are two controllers, one is connected to the internal
> PHYs, the other one can communicate with external PHYs.
> 
> Reviewed-by: Andrew Lunn <and...@lunn.ch>
> Signed-off-by: Alexandre Belloni <alexandre.bell...@bootlin.com>

Nothing critical, so:

Reviewed-by: Florian Fainelli <f.faine...@gmail.com>

[snip]

> +static int mscc_miim_reset(struct mii_bus *bus)
> +{
> +     struct mscc_miim_dev *miim = bus->priv;
> +
> +     if (miim->phy_regs) {
> +             writel(0, miim->phy_regs + MSCC_PHY_REG_PHY_CFG);
> +             writel(0x1ff, miim->phy_regs + MSCC_PHY_REG_PHY_CFG);
> +             mdelay(500);

Can this become an msleep() in the future?

> +     }
> +
> +     return 0;
> +}
> +
> +static int mscc_miim_probe(struct platform_device *pdev)
> +{
> +     struct resource *res;
> +     struct mii_bus *bus;
> +     struct mscc_miim_dev *dev;
> +     int ret;
> +
> +     res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> +     if (!res)
> +             return -ENODEV;
> +
> +     bus = devm_mdiobus_alloc_size(&pdev->dev, sizeof(*dev));
> +     if (!bus)
> +             return -ENOMEM;
> +
> +     bus->name = "mscc_miim";
> +     bus->read = mscc_miim_read;
> +     bus->write = mscc_miim_write;
> +     bus->reset = mscc_miim_reset;
> +     snprintf(bus->id, MII_BUS_ID_SIZE, "%s-mii", dev_name(&pdev->dev));
> +     bus->parent = &pdev->dev;
> +
> +     dev = bus->priv;
> +     dev->regs = devm_ioremap_resource(&pdev->dev, res);
> +     if (IS_ERR(dev->regs)) {
> +             dev_err(&pdev->dev, "Unable to map MIIM registers\n");
> +             return PTR_ERR(dev->regs);
> +     }
> +
> +     res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
> +     if (res) {
> +             dev->phy_regs = devm_ioremap_resource(&pdev->dev, res);
> +             if (IS_ERR(dev->phy_regs)) {
> +                     dev_err(&pdev->dev, "Unable to map internal phy 
> registers\n");
> +                     return PTR_ERR(dev->phy_regs);
> +             }
> +     }
> +
> +     if (pdev->dev.of_node)
> +             ret = of_mdiobus_register(bus, pdev->dev.of_node);
> +     else
> +             ret = mdiobus_register(bus);

There are other drivers doing that, we should probably make that the
standard behavior of of_mdiobus_register(), like before, candidate for
another patch.
-- 
Florian

Reply via email to