David Miller wrote:
From: Larry Finger <[EMAIL PROTECTED]>
Date: Sat, 23 Sep 2006 16:40:15 -0500
The maximum value for MTU is set in include/linux/if_ether.h for all
ethernet-type communications, not in softmac or ieee80211. I doubt
that one could easily change the number. It may be that the 802.11
standard allows bigger frames, but it looks to me as if Linux does
not.
Not correct. Linux is perfectly fine with setting 9000 byte MTU on
ethernet devices that support it, and in fact just about every
gigabit ethernet driver supports it.
That macro you see in if_ether.h is just the value of the base MTU
limit, so larger MTU settings are easily allowable on a per-device
basis.
Where/how does the device allow it? When I tried 'ifconfig eth0 mtu 2000' on my VIA Technologies,
Inc. VT6102 [Rhine-II] wired controller, I got a 'SIOCSIFMTU: Invalid argument' message, which is
the same message I get on my BCM4306 wireless card.
Larry
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
