From: Eran Ben Elisha <era...@mellanox.com>
In mlx4_en_reset_config, there was a redundant warn print that was left
from previous versions of this function. No warn is needed anymore.
This warn can be confusing when RX-FCS is changed:
Turn OFF RX-FCS:
mlx4_en: eth1: Changing device configuration rx filter(0) rx vlan(1)
Turn ON RX-FCS:
mlx4_en: eth1: Changing device configuration rx filter(0) rx vlan(1)
Signed-off-by: Eran Ben Elisha <era...@mellanox.com>
Signed-off-by: Tariq Toukan <tar...@mellanox.com>
---
drivers/net/ethernet/mellanox/mlx4/en_netdev.c | 4 ----
1 file changed, 4 deletions(-)
diff --git a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
index b62d2c3f976a..e0adac4a9a19 100644
--- a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
+++ b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
@@ -3634,10 +3634,6 @@ int mlx4_en_reset_config(struct net_device *dev,
mlx4_en_stop_port(dev, 1);
}
- en_warn(priv, "Changing device configuration rx filter(%x) rx
vlan(%x)\n",
- ts_config.rx_filter,
- !!(features & NETIF_F_HW_VLAN_CTAG_RX));
-
mlx4_en_safe_replace_resources(priv, tmp);
if (DEV_FEATURE_CHANGED(dev, features, NETIF_F_HW_VLAN_CTAG_RX)) {
--
1.8.3.1
