From: Rafał Miłecki <ra...@milecki.pl> Some of Broadcom's PHYs run by default in slave mode with Automatic Slave/Master configuration disabled. It stops them from working properly with some devices.
So far it has been verified for BCM54210E and BCM50212E which don't work well with Intel's I217-LM and I218-LM: http://ark.intel.com/products/60019/Intel-Ethernet-Connection-I217-LM http://ark.intel.com/products/71307/Intel-Ethernet-Connection-I218-LM I was told there is massive ping loss. This commit adds support for a new flag which can be set by an ethernet driver to fixup PHY setup. Signed-off-by: Rafał Miłecki <ra...@milecki.pl> --- drivers/net/phy/broadcom.c | 6 ++++++ include/linux/brcmphy.h | 1 + 2 files changed, 7 insertions(+) diff --git a/drivers/net/phy/broadcom.c b/drivers/net/phy/broadcom.c index 1e9ad30a35c8..d7ed69deabfb 100644 --- a/drivers/net/phy/broadcom.c +++ b/drivers/net/phy/broadcom.c @@ -43,6 +43,12 @@ static int bcm54210e_config_init(struct phy_device *phydev) val &= ~BCM54810_SHD_CLK_CTL_GTXCLK_EN; bcm_phy_write_shadow(phydev, BCM54810_SHD_CLK_CTL, val); + if (phydev->dev_flags & PHY_BRCM_EN_MASTER_MODE) { + val = phy_read(phydev, MII_CTRL1000); + val |= CTL1000_AS_MASTER | CTL1000_ENABLE_MASTER; + phy_write(phydev, MII_CTRL1000, val); + } + return 0; } diff --git a/include/linux/brcmphy.h b/include/linux/brcmphy.h index abcda9b458ab..9ac9e3e3d1e5 100644 --- a/include/linux/brcmphy.h +++ b/include/linux/brcmphy.h @@ -63,6 +63,7 @@ #define PHY_BRCM_EXT_IBND_TX_ENABLE 0x00002000 #define PHY_BRCM_CLEAR_RGMII_MODE 0x00004000 #define PHY_BRCM_DIS_TXCRXC_NOENRGY 0x00008000 +#define PHY_BRCM_EN_MASTER_MODE 0x00010000 /* Broadcom BCM7xxx specific workarounds */ #define PHY_BRCM_7XXX_REV(x) (((x) >> 8) & 0xff) -- 2.11.0
