Dan Williams <[email protected]> wrote:
[...]
>You'll probably say "aim for the 75% case" or something like that,
>which is fine, but then you're depending on your 75% case to be (a)
>single AP, (b) never move (eg, only bond wifi + ethernet), (c) little
>radio interference. I'm not sure I'd buy that. If I've put words in
>your mouth, forgive me.
The primary use case that I'm aware of for bonding with wireless
devices is in active-backup mode, paired with an ethernet adapter set as
the bonding "primary" device. I think this is the case that absolutely
should just work. I don't think bonding cares (or should care) about
(a) - (c) for this use.
Your point (b) suggests that there are use cases other than the
above; I'm unfamiliar with any use other than wifi + ethernet, can you
elaborate?
-J
---
-Jay Vosburgh, [email protected]
