Wed, Aug 16, 2017 at 06:15:53AM CEST, [email protected] wrote:
>RmNet driver provides a transport agnostic MAP (multiplexing and
>aggregation protocol) support in embedded module. Module provides
>virtual network devices which can be attached to any IP-mode
>physical device. This will be used to provide all MAP functionality
>on future hardware in a single consistent location.
>
>Signed-off-by: Subash Abhinov Kasiviswanathan <[email protected]>
[...]
>+struct rmnet_phys_ep_conf_s {
The name is cryptic. Why "_s"?
>+ struct net_device *dev;
>+ struct rmnet_logical_ep_conf_s local_ep;
>+ struct rmnet_logical_ep_conf_s muxed_ep[RMNET_MAX_LOGICAL_EP];
>+ u32 ingress_data_format;
>+ u32 egress_data_format;
>+ struct net_device *rmnet_devices[RMNET_MAX_VND];
>+};
>+
>+extern struct rtnl_link_ops rmnet_link_ops;
>+
>+struct rmnet_vnd_private_s {
Again, cryptic.
>+ struct rmnet_logical_ep_conf_s local_ep;
>+ u32 msg_enable;
>+};
[...]
>+rx_handler_result_t rmnet_ingress_handler(struct sk_buff *skb)
>+{
>+ struct rmnet_phys_ep_conf_s *config;
I still fail to understand why the name of this is "config". Please
change to something else across whole code. Including the name of the struct.
>+ struct net_device *dev;
>+ int rc;
>+
>+ if (!skb)
>+ return RX_HANDLER_CONSUMED;
>+
>+ dev = skb->dev;
>+ config = rmnet_get_phys_ep_config(skb->dev);
You have dev. Why not use dev?
>+
>+ /* Sometimes devices operate in ethernet mode even thouth there is no
>+ * ethernet header. This causes the skb->protocol to contain a bogus
>+ * value and the skb->data pointer to be off by 14 bytes. Fix it if
>+ * configured to do so
>+ */
>+ if (config->ingress_data_format & RMNET_INGRESS_FIX_ETHERNET) {
>+ skb_push(skb, RMNET_ETHERNET_HEADER_LENGTH);
>+ rmnet_set_skb_proto(skb);
>+ }
>+
>+ if (config->ingress_data_format & RMNET_INGRESS_FORMAT_MAP) {
>+ rc = rmnet_map_ingress_handler(skb, config);
>+ } else {
>+ switch (ntohs(skb->protocol)) {
>+ case ETH_P_MAP:
>+ if (config->local_ep.rmnet_mode ==
>+ RMNET_EPMODE_BRIDGE) {
>+ rc = rmnet_ingress_deliver_packet(skb, config);
>+ } else {
>+ kfree_skb(skb);
>+ rc = RX_HANDLER_CONSUMED;
>+ }
>+ break;
>+
>+ case ETH_P_ARP:
>+ case ETH_P_IP:
>+ case ETH_P_IPV6:
>+ rc = rmnet_ingress_deliver_packet(skb, config);
>+ break;
>+
>+ default:
>+ rc = RX_HANDLER_PASS;
>+ }
>+ }
>+
>+ return rc;
>+}
>+
>+rx_handler_result_t rmnet_rx_handler(struct sk_buff **pskb)
>+{
>+ return rmnet_ingress_handler(*pskb);
This is just silly. Why you don't have the content of rmnet_ingress_handler
right here?
